Guides · specification
How to choose battery powered LED uplights
Six numbers decide whether a battery fixture will do the job you are quoting for. Everything else on the datasheet is detail.
The short version. Match the runtime to the colour mode you will really run, check the battery in watt-hours rather than amp-hours, confirm the beam angle for the throw you have, and weigh the charging case — that is what your crew carries at two in the morning.
1. Start from the colour mode, not the headline runtime
Every battery fixture quotes its best number. A 12-hour runtime usually means a single colour at moderate output. The moment you start mixing colours, more LED dies switch on and the battery drains faster. Ask for the runtime row by row.
Typical pattern across our range: 12 hours single colour, 7 to 8 hours dual colour, 4 hours full RGBW. If your show is a four-hour reception with colour changes all night, a 4-hour RGBW figure leaves no margin — plan a second set of fixtures or run a single colour.
2. Compare the battery in watt-hours
Amp-hours alone tell you nothing without voltage. Multiply volts by amp-hours to get watt-hours, the actual energy in the pack. Two fixtures can both say 18 Ah and hold very different energy if one runs at 11.1 V and the other at 22.2 V.
NEO 6 carries 11.1 V 13.2 Ah, roughly 146 Wh. ENZO 18 carries 22.2 V 18 Ah, roughly 400 Wh. Both run about twelve hours on a single colour because NEO 6 drives six 20 W LEDs and ENZO 18 drives eighteen — the bigger pack pays for the bigger engine.
3. Check the beam angle against your throw distance
A 25 degree lens is the usual default. It gives a spot roughly 0.44 times the throw distance in width: 1.3 m at 3 m, 3.5 m at 8 m. If you are lighting a 6 m façade from the ground, 25 degrees is right. If you are washing a wall from half a metre away, 25 degrees is too tight and you want a 45 degree lens or a zoom.
Ask whether the lens is interchangeable and whether there is a zoom option. On NEO 6 and ENZO 18 the 25 degree lens is standard, 15 and 45 degree lenses are optional, and a PDLC smart-glass zoom covers 25 to 60 degrees without touching the hardware.
4. Treat the IP number as a decision, not a badge
IP65 means dust tight and protected against water jets. IP54 means dust protected and protected against splashing only. An outdoor ceremony, a façade wash or a fixture that gets hosed down between events is an IP65 job. A ballroom or a fully tented marquee can live with IP54. The difference in price is real; the difference in failures after a rainy weekend is also real.
5. Weigh the case, not just the fixture
NEO 6 is 2.4 kg and ships ten to a charging case. ENZO 18 is 8.4 kg and ships four to a charging case. A ten-unit case is a two-person lift and a van shelf; four ENZO 18 in a case is a trolley job. Work out the case count for your room before you choose the model — it changes the transport and the crew time more than the fixture price does.
6. Confirm what is actually built into the wireless
Every fixture in this range has a 2.4 GHz wireless DMX-512 receiver on the board. AirDMX is the standard link, with sixteen ID groups, a four-group RF remote and AirApp control. W-DMX G3 / G4 / G4S or LumenRadio CRMX are built on request. If your rental house already runs W-DMX, say so at quotation stage — it is a build option, not a field upgrade.
The six questions to send every supplier
- Runtime in single colour, dual colour and full RGBW, measured how?
- Battery voltage, capacity and whether the BMS is protected against deep discharge?
- Beam angle as standard, and which lenses or zoom are available?
- IP rating stated on the datasheet, plus the rating of the cable connectors?
- DMX channel map and how the wireless receiver pairs?
- Are the cells UN38.3 tested — the document you need to ship lithium by air?
Worked comparison: NEO 6 and ENZO 18
| Figure | NEO 6 | ENZO 18 |
|---|---|---|
| LEDs | 6 x 20 W ceramic SMD | 18 x 20 W ceramic SMD |
| Battery | 11.1 V 13.2 Ah | 22.2 V 18 Ah |
| Runtime | 12 h single / 7 h dual / 4 h RGBW | 12 h single / 8 h dual / 4 h RGBW |
| Beam | 25° standard, 15° / 45° lenses, PDLC 25–60° | 25° standard, 15° / 45° lenses, PDLC 25–60° |
| Body | 124 x 131 x 146 mm, 2.4 kg | 376 x 175 x 256 mm, 8.4 kg |
| Power | 72 W, charger DC 12.6 V | 216 W, AC 110–240 V, PowerCON TRUE1 |
| Case | 10 per charging case | 4 per charging case |
Questions we get asked
Is a bigger battery always better? No. Bigger packs mean more weight and more cost. Match watt-hours to the shows you actually run, and keep a spare set rather than buying one oversized set.
Can I mix battery and mains fixtures on one console? Yes. They share the same DMX-512 universe; the difference is only where the power comes from.
Do battery fixtures need a charging room? They need a circuit and a shelf. Ten NEO 6 charge in one case on a normal wall socket; that is usually easier than finding sockets in the venue.
Need a quotation for a specific room? Send the wall length, the number of looks you need and whether the venue is outdoors. We answer with a fixture count, a runtime estimate and a charging plan.
Request a quote