Guides · optics
Beam angle and placement: what 25 degrees actually covers
A 25 degree lens is the standard on every battery fixture here. This is the spot size it gives at each throw distance, and how to space fixtures for a wash that does not stripe.
The maths, once
Spot diameter is twice the throw distance multiplied by the tangent of half the beam angle. For a 25 degree lens, half the angle is 12.5 degrees, whose tangent is about 0.22 — so the spot is roughly 0.44 times the distance.
That single number explains most placement problems. A fixture half a metre from a wall paints a stripe 0.22 m wide. The same fixture three metres from a wall paints 1.3 m. Same lens, same output, completely different job.
Spot size by distance
| Throw | 25° spot | 15° spot | 45° spot |
|---|---|---|---|
| 2 m | 0.9 m | 0.5 m | 1.7 m |
| 3 m | 1.3 m | 0.8 m | 2.5 m |
| 5 m | 2.2 m | 1.3 m | 4.1 m |
| 8 m | 3.5 m | 2.1 m | 6.6 m |
| 10 m | 4.4 m | 2.6 m | 8.3 m |
When to change the lens
15 degrees is a punch beam: pillars, trees, a single artwork, a long façade where you want concentrated colour. It is the wrong lens for a wall wash — the spots will separate.
45 degrees is the wash lens: closer walls, low ceilings, a continuous sheet of colour with fewer fixtures. On a wedding wall, 45 degrees at 1 m gives a 0.8 m spot instead of 0.44 m, which is the difference between stripes and a wash.
PDLC zoom 25–60 degrees does the same job without opening the fixture: dial the beam to the room. It is the option to specify when one rental stock has to cover both tight pillars and wide walls.
Spacing for an even wash
For a continuous wash, space the fixtures so the spots overlap by roughly half. At a 3 m throw with 25 degrees the spot is 1.3 m, so units every 0.7 to 0.9 m give an unbroken line; every 1.5 m gives separate pools.
Along a wall the geometry is compressed: an uplight 0.5 m from the wall has a 0.5 m throw to the wall, so the spot is 0.22 m. This is why floor uplights close to a wall look like stripes with a narrow lens — move them out to 1 to 1.5 m, or fit the 45 degree lens, or open the zoom.
Angle and height
- Aim slightly up the wall, not at the ceiling. The wash reads on the wall, and the ceiling picks up a soft bounce.
- On a façade, keep the lower edge of the beam on the wall and let the top reach the eaves.
- Tilt the body rather than moving it: the yoke on ENZO 18 and the bracket on NEO 6 exist so the beam can be aimed without re-rigging.
Questions we get asked
Is a 25 degree lens enough for a 6 m wall? From the floor, yes: at 6 m the spot is about 2.7 m wide, so two fixtures cover the wall with a slight overlap.
Can I see the beam in the air? In a hazy or smoky room, yes. In clean air, a 25 degree par reads as a wash on the surface, not as a visible shaft — that is normal for a lens this wide.
Does the lens change the colour? No. It changes the spread and the intensity per square metre, not the colour mix.
Need a quotation for a specific room? Send the wall length, the number of looks you need and whether the venue is outdoors. We answer with a fixture count, a runtime estimate and a charging plan.
Request a quote